Batteryminder SureGuard 12100 Manuale Utente Scaricare il pdf

You have just purchased a very simple, yet

accurate battery management “Assistant”

designed to help you know, at the push of

the button, the condition of your battery

and charging / alternator system.

SureGuard protects your sensitive engine

computer system and 12 volt accessories

such as your security system, radar detec-

tor, cellular phone, personal computer,

etc., from momentary surges during

“jump starting” or charging.

SureGuard

INSTALLATION:

Turn engine and ALL accessories off

• Disconnect the Black ( - ) ground lead

wire from your battery

• Carefully think of the best location on

or near your battery to locate your

SureGuard so it can be easily seen and

read. Clean surface you plan to attach

SureGuard to using an alcohol pad.

• Attach the ring terminal on RED wire of

SureGuard to the ( + ) clamp of battery

• Attach ring terminalofBlackwire of the

SureGuard to the ( – ) clamp of battery

• Then attach SureGuard using both

Velcro strips supplied.

• Re-connect the BLACK ( – ) ground

lead wire to the ( – ) battery post.

SureGuard

OPERATION:

Note: For the most accurate readings always

allow your battery to “Rest” for a minimum

period of 12 hours, ie. without charging or

discharging or running your engine. Further

test battery only with engine and all acces-

sories and lights turned off. Test alternator /

charging system only when engine is running

and without lighting/accessories turned on.

TO TEST BATTERY

(Engine and ALL accessories must be off

for accurate reading ):

• Press the area on the face of your

SureGuard marked “PUSH” (Engine or

power using lighting or accessories should

not be “on” at the same time.) The follow-

ing will give you the actual voltage ranges

the various colored LEDs ( red, yellow,

green ) correspond with:

NO LIGHT= LESS THAN 11.2 VOLTS

RED = POOR = 11.2-11.8 Volts

= Battery may be “DEAD”, severely shorted, or

deeply discharged. If in doubt replace.

YELLOW = FAIR = 11.8-12.3 Volts

(Both Red & Yellow LED’s will light)

= Battery may be shorted or discharged and unable

to start your vehicle. Check charging system

GREEN = GOOD = 12.3-12.8 Volts

(All 3 LED’s will light)

= Battery is “healthy”

TO TEST ALTERNATOR /

CHARGING SYSTEM

(Engine MUST be Running):

• Press the area on the face of the

SureGuard marked “PUSH”

• GREEN LED marked Alternator should be lit

(13.2-14.2 volts). If it does not show Green,

Alternator / charging system is faulty and

must be checked / repaired.

Note: All 4 LED’s will light if OK.

Operating and Installation Instructions for

SureGuard

POOR

FAIR

GOOD

CHARGER /ALTERNATOR

with

V-Spike Surge Protector

™

Protects Engine Computer

and 12v accessories

Battery/Charging

Monitor

PUSH

1 2

SureGuard 1
#84599-BCBAAb 2

Sommario

Pagina 1 - SureGuard

You have just purchased a very simple, yetaccurate battery management “Assistant”designed to help you know, at the push ofthe button, the condition of

Pagina 2 - #84599-BCBAAb

Made in China exclusively for:VDC Electronics,Inc.Mail: P.O. Box 5537,Englewood NJ 07631-5537Tel: ( 800 ) 379-5579 5 YEAR LIMITED WARRANTYSureGuard i

Commenti su questo manuale

Nessun commento

Batteryminder SureGuard 12100 Manuale Utente

Navigare online o scaricare Manuale Utente per Alimentatori elettrici Batteryminder SureGuard 12100. BatteryMINDer SureGuard 12100 User Manual Manuale Utente

Sommario

Commenti su questo manuale

Prodotti e manuali riguardandi Alimentatori elettrici Batteryminder SureGuard 12100